Welcome to your new vision sticks! They are a truly sweet pair of glowstringer-inspired poi and we expect you'll have an incredible time with them :) 


On this page, you'll find information on how to:

  • charging your lights
  • adjusting/finishing your j-lace leashes
  • swapping the leashes to a different type 
  • links to the various FlowOS modes/setting support resources 



Charging your lights:


There is a 'button cover' on the bottom end of each vision stick. 


To open it:

  • squeeze the 'super F' logo at the base of the stick - this will cause the button cover to pop open. 
  • from there, peel off the button cover to expose the charging port


Check out the video below for a walk-through on how to access the charging port on your vision sticks. It also includes information about adjusting the j-lace leashes!





Finishing your j-lace leashes:


The video above includes information about how to adjust the j-lace leashes, and we have some detailed photos of to make the j-lace knot below.




Can I use flowleash plus (or another 6mm diameter leash) on my vision sticks?


Absolutely! We have included DIY instructions below. 


If you prefer to use your rig with our flowleash plus kits, here's how to do that: 

  • Order a set of smithy cord flowleash plus (choose leash end = no washer), and follow the steps below. 


Tools you'll need:

  • scissors
  • lighter 
  • sharp razor blade
  • cutting surface




Step by step assembly instructions:

  • remove your vision stick board from the case, detailed instructions are in the video above. 
  • remove the j-lace
  • modify the vision stick case for flowleash:


  • pull the loose o-ring off of your flowleash plus, and set aside 
  • pass one end of the flowleash thru the vision case
  • then replace the loose o-ring
  • pivot the battery to access the leash connection, and pass the cord thru the bottom of the vision board

            ^This is the only step thats different than the crystal case video^

  • pass the tip of the cord back through the loose o-ring (you may need pliers, melting and reshaping the tip of the cord may help)
  • once through the loose o-ring, melt the end of the flowleash and press it into the side of your lighter to create a wide puck
  • once cooled, hold the ring, and pull the puck down to meet it
  • then pull out slack, snugging the ring down perpendicular against the board


The 3d-printed case only needs a tiny bit cut off its tip to accommodate smithy cord. 


Pro tip: It is possible to count the layers of the 3d print to find your exact cut. Your cut is 7 layers in from the tip.


The video covers how to modify a crystal case for smithy cord - the process is almost identical, there's just a more specific cut to be made on the vision sticks.


When you hold your vision stick case up to the light, it's possible to see where the inner structure transitions from a cone to a short cylinder. Your goal is to cut off the cylinder and nothing more.


To finish:

  • align the board with the case
  • use the tether to pull the board back into the case
  • size, cut and finish your leashes, using the same melted puck and ring method
  • you are ready to flow!



Other useful resources to get the most out of your vision sticks: