Staffs & batons :: contact, twirling, dragon, martial, juggling, travel/collapsible, cane and more

How to assemble, disassemble staffs, and all other hardware questions. For how to use lights, please refer to the relevant light engine category.

Lumina twirl baton quickstart guide - how to charge, group lights, basic navigation
Welcome to the world's favorite glow baton, used by professionals on stages all over the world! Check out the resources below to get started on your jou...
Fri, 6 Feb, 2026 at 12:43 PM
Vision cane quickstart guide - how to assemble, charge lights, handle options, tips for the quad tip base, using cane as mobility device
Welcome to your new vision cane! We are thrilled to be able to offer these wonderful performance props and hope you have an incredible time with yours :)  ...
Tue, 17 Feb, 2026 at 4:34 PM
Travel staff quickstart guide - how to assemble, charge lights
Welcome to your new travel staff! Whether you're touring the world or going to your local flowjam this page covers the basics of using your travel staff...
Fri, 6 Feb, 2026 at 12:42 PM
Trikon dragon hub quickstart guide - how to install, tighten bolt, swap hub adaptors, general troubleshooting
Trikon hubs fit any of the 3 most common dragon staff diameters with a shaft adaptor: 19mm (3/4”) with 19mm adaptor 22mm (7/8”) with 22mm adaptor 25mm (...
Fri, 6 Feb, 2026 at 12:42 PM
Flowbonacci dragon staff quickstart guide - assembling the collapsible shaft and hubs
Welcome to your new Flowbonacci dragon staff! Get ready to let the good times roll ;) This page includes 2 videos to help you get started with your new drag...
Wed, 4 Feb, 2026 at 3:41 PM
My dragon staff shaft is missing plugs at each end - is this normal?
Yes, it is normal for your dragon staff shaft to be open on both ends.  The shaft plugs typically serve 2 functional purposes: Keep out dirt Prevent ...
Mon, 12 Jan, 2026 at 11:01 AM
How to break down a vision / composite staff for travel
Yes, you can break down your vision or composite staff for travel!  Vision/composite staffs after 2025:  As of 2025 we transitioned all our vision/c...
Wed, 4 Feb, 2026 at 4:11 PM
How to install / remove the flowcap
To attach flowcaps to flowtoys tubes, place the cap over tube, push and twist until flowcap buttons click into the tubing holes.  To detach, twist to rele...
Wed, 4 Feb, 2026 at 4:11 PM
How to: prevent rattling in staffs and other tube-based props
Notice slight vibrations or rattles? Most people don’t, but if you are super sensitive and want to prevent rattling in your tubes - there is a solution! ...
Wed, 25 Feb, 2026 at 4:26 PM
Using pod shells and sleeves as end caps
Yes, you can use pod shells as end caps for your composite staff. We don't offer pod shells as a standard cap option for the following reasons: Flowca...
Wed, 4 Feb, 2026 at 4:12 PM